New York Firearms Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
554 Posts
Discussion Starter #1
Thinking about replacing my handguard and putting on a low profile gas block on my RRA Elite Operator. The muzzlebreak isn't pinned, so that should make it easier. Just curious on what a fair price would be to swap them out? Any help is appreciated.

Thanks
Adam
 

·
Registered
Joined
·
2,099 Posts
Sadlack or Keis gas block will be just over $30

Then the expensive part, what hand guard/rail do you want to run. Smoooth? railed?
 

·
Registered
Joined
·
554 Posts
Discussion Starter #4
Already picked out the Midwest Industries SS-12.

Also already purchased a Troy low profile gas block.
 

·
Registered
Joined
·
554 Posts
Discussion Starter #5
Perhaps I wasn't clear. I'm wondering what a reasonable price would be to have a gunsmith swap everything out for me? Just looking for a labor cost.
 

·
Registered
Joined
·
2,099 Posts
The MD is not pinned?

if so, the swap should be $35-50 bucks depending on how they charge.
 
1 - 7 of 7 Posts
Top