New York Firearms Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey guys,

I'm new to this forum and sorry if there's a thread already about this.

So guys I'm looking for a change of sights for my saiga. Me being very fond of my iron sights I'm used to from the marine corps I pretty much don't find much that's truer. So do any of you guys know of and lower profile rear sights because I already and losing a little stock cheek weld as is and with my side mounted picatinny rail that about 1/2 inch above the upper receiver.

Any suggestions thanks in advance.
 

·
Registered
Joined
·
1,009 Posts
There are other sights available but none that I know of which are low-profile. I know Troy makes them for AR's, but even the Troy micro rear iron sight would be higher than the saiga factory.

Best bet may be to find another stock, or grab a cheek riser kit.

Thank you for your service and welcome to the forums sir.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks hk. I appreciate it and thank you guys for support. I'll look around and do my homework. I think I'm going to look for a different sight or a different picatinny rail mod because the angle for the hight compensation is ridiculous.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top