New York Firearms Forum banner
1 - 1 of 4 Posts

· Registered
599 Posts
Discussion Starter · #1 ·
Ok im going with a new setup on my Remington 700 sps in .308. I am ordering this scope Bushnell tactical 10x40 URL Now i am stuck on what size rings to get and to go with a 20moa base or flat. I ASSUME i should stick with low rings but what rings can i get for around $50 that are not garbage? And i was going to get the EGW 1 piece base but should i get the 20moa or standard flat? I plan to zero in at 100yd and shoot most of the time from 100yd to 500yd but occasionally up to 1000yd. Any suggestions? Thanks!!

Also should i go mil/mil or mil/moa on scope? I dont even see the mil/mil scope listed on the bushnell website?
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.