New York Firearms Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Shotguns
    http://www.rem870.com/2012/07/20/reming ... te-nordic/ thought some may find this helpful. im more than likely going to replace the follower on my 930 so I thought this was a good read. im leaning towards the gg&g or s&j hardware delrin follower, but not sure yet. anyone have any suggestions...
  2. The AR-15
    When you take off the floor plate there is a little tab on the opposite side from where the floor plate slides off. It prevents you from removing the follower. I was going to just clip it but decided to get some input first. Will it hurt anything to cut it? Secondly, has anyone changed...
  3. Handguns
    Looking for a how to- Last time it was done for me, and I wasn't paying attention (at least I'm honest) and so I'm not 100% on this. I thought I just had to "smash" the base plate away from the mag? Anything specific to do to make this easy, or just use a ledge, or?
  4. The AR-15
    Will magpul followers and ranger plates fit orlite 39 round magazines? I've searched and can't find a answer! Thanks!
  5. Handguns
    I'm not having much luck easily finding anything thru google, but then again, perhaps I don't know exactly what i'm looking for. Direct links to replacement followers, or perhaps if you know what (if any) specific marks may be on them to help me identify what to get would be great. Thanks
1-5 of 5 Results
Top